[lug] eth0 puzzle

[gordongoldin at netscape.net]

  I had a FC3 server at a remote site. It has 2 NIC cards: Intel gigabit and D-Link
 
 eth0 goes to Intel gigabit and uses DHCP
 eth1 goes to D-Link and uses static
 
 I brought it back in, attached network to eth0 and it attached with DHCP.
 Eth0 is active eth1 is inactive.
 ifconfig and route looks just like the machine next to it.
 
 It can ping locally (including gateway) but cannot get out.
 
 I pulled the drive, installed FC5 (not 6 because we have to test all systems on 6 before going on).
 eth0 was plugged in, eth1 not
 
 eth0 came up on DHCP
 eth1 showed as inactive in Network configuration. When I pressed edit, it said "could not find configuration".
 
 So I deleted eth1. and rebooted. It showed up again. Deleted again and rebooted. It didn't show up.
 deleted eth0 and reconfigured eth0. and rebooted. and deleted and reconfigured as static at the same address. and re-activated, and rebooted, etc. etc.
 Tried all this several times.
 
 Always the same - can get on locally but cannot get out on eth0.
 
 Any ideas?
 
________________________________________________________________________
Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.lug.boulder.co.us/pipermail/lug/attachments/20070111/a8568375/attachment.html>