No subject

SCSI subsystem driver Revision: 1.00
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.5
        <Adaptec aic7890/91 Ultra2 SCSI adapter>
        aic7890/91: Ultra2 Wide Channel A, SCSI Id=7, 32/253 SCBs

scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.5
        <Adaptec 2940 Ultra2 SCSI adapter>
        aic7890/91: Ultra2 Wide Channel A, SCSI Id=7, 32/253 SCBs

  Vendor: IBM       Model: DRVS09V           Rev: 0140
  Type:   Direct-Access                      ANSI SCSI revision: 03
scsi0:A:0:0: Tagged Queuing enabled.  Depth 253
  Vendor: CHAPTEC   Model: G5312             Rev: 2.0.
  Type:   Processor                          ANSI SCSI revision: 02
scsi1:A:0:0: Tagged Queuing enabled.  Depth 253
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:A:0): 80.000MB/s transfers (40.000MHz, offset 15, 16bit)
SCSI device sda: 17928698 512-byte hdwr sectors (9179 MB)
Partition check:
 sda: sda1 sda2 sda3

---

I've already Googled fruitlessly. Any advice or pointers would be
greatly appreciated.