[lug] Re: SB AWE32 Errors

[D. Stimits]

SoloCDM wrote:
> 
> "D. Stimits" stated the following:
> >
> > SoloCDM wrote:
> > >
> > > I found the following modules for a Creative SB AWE32, with kernel
> > > 2.2.14-15:
> > >
> > > /sbin/modprobe sound; /sbin/modprobe isapnp; /sbin/modprobe
> > > joy-creative; /sbin/modprobe joystick; /sbin/modprobe snd-card-sbawe;
> > > /sbin/modprobe snd-midi; /sbin/modprobe snd-mpu401-uart;
> > > /sbin/modprobe snd-hwdep; /sbin/modprobe snd; /sbin/modprobe snd-pcm;
> > > /sbin/modprobe soundcore; /sbin/modprobe snd-sb16-csp; /sbin/modprobe
> > > snd-sb16-dsp; /sbin/modprobe snd-mixer; /sbin/modprobe snd-opl3;
> > > /sbin/modprobe snd-wavefront-synth; /sbin/modprobe awe_wave;
> > > /sbin/modprobe snd-hwdep; /sbin/modprobe snd-card-sbawe; /sbin/insmod
> > > opl3; /sbin/insmod sb io=0x220 irq=5 dma=1 dma16=5 mpu_io=0x330;
> > > /sbin/insmod uart401
> > >
> > > My sound worked perfectly with kernel 2.0.36.  I have my CDROM
> > > connected to the IDE controller card.  Every time I run sndconfig
> > > with(out) global $DISPLAY environment variable, as per instructions,
> > > I get the following errors:
> > >
> > > Don't know what to do with CONFIGURE CTL0044/941569 (LD 2 on or
> > > around line 353 /etc/isapnp.conf:353 -- Fatal - Error occurred
> > > parsing config file --- no action taken
> >
> > FYI, this is not a module error. This is for setting up plug-n-play ISA
> > cards so that their hardware settings can match what either the kernel
> > or the modules are set to use. I don't know if maybe the version of
> > isapnptools also required a change/upgrade when going from the old 2.0.x
> > to 2.2.x. You might want to post about a half dozen lines before and
> > after line 353 (and mark 353) for /etc/isapnp.conf. Plus back it up so
> > you can experiment, e.g., rerun isapnpdump and edit again.
> 
> I didn't upgrade from 2.0.x to 2.2.x.  I overhauled the entire disk --
> formatted the disk, installed new OS, which included kernel 2.2.x.  I
> incorporated configurations from the old OS by modifying them to fit
> the present platform.  I used sndconfig to create /etc/isapnp.conf.
> 
> > > What must be done to fix this problem?
> 
> Note: When you reply to this message, please include the mailing
>       list/newsgroup address in Cc: and my email address in To:.
> 

It sounds like sndconfig is broken. Is the sound card in fact an ISA
slot, plug-n-play card? What are the lines surrounding the error line of
/etc/isapnp.conf? I would still guess that sndconfig is reading this
file but it is generated by isapnptools (I assume since the file is
there and not copied from the old install that isapnptools was
installed).

D. Stimits, stimits at idcomm.com